bgz wrote:I know we've been throwing some jabs at each other, but I'm interested in what you made.
Kicking myself for not keeping stuff, but all we did was make test plaques so the customer (actually, they make the graphene so they're also the vendor) could test different blends.
Mostly graphene filled PLA filaments.
Our printer runs 3mm and they needed 1.75mm so we didn't get much to play with.
The carbon nanotube products we run are mostly in a fluoropolymer (PVDF) base resin, so we don't run them in our printer because printers are primitive by design and hang up areas can result in burning and hydrofluoric acid sucks. But I've seen the test results and they're quite similar.
They sell their graphene PLA filament through blackmagic3d .com
They extrude their own filament now, although we do run specialties now and then.