Mo'sMan
Wednesday, February 16, 2005 2:30:00 PM
I ordered a pound directly from the site. It was over a week ago now but I suspected it would take some time given the experience of others here. I have a second tupperware container the same size as the one I have my foam and 50/50 solution in. I'll add the proper amount of media for 300 sticks and place it along side the foam/solution container.

I also have a few aluminum? tubos I have drilled with small holes along the sides. I then replaced the thin cedar strips that came from inside them to act as a screen. I'll fill each with enough media for about 30 cigars, moisten as directed and place them into my boxes.

8trackdisco
Wednesday, February 16, 2005 2:58:00 PM
I was feeling pretty good about this process until I read Steve's post.

I have to keep in mind the ratio of PG to distilled water, area of humidor, and ambient room temp and RH?

Damn, I should have paid attention in math class. 😉

I have a friend who is a high school math teacher. I'll tell him this story. The next time some smart mouth kid says 'when am I going to use this in the real world', he'll have a snappy, cigar related reply.

I hope this process is easier to figure out than women and the Metric System.

8

xrundog
Wednesday, February 16, 2005 3:00:00 PM
You guys are getting mixed up here. There are BEADS and there are CRYSTALS. They are NOT the same. You only use distilled water with beads.
8trackdisco
Wednesday, February 16, 2005 3:03:00 PM
Ah yes, my fault. I am mixing and matching the terms. It would seem to be the crystals are slightly higher maintenance than the beads.

Thanks for the clarification.

8

Mo'sMan
Thursday, February 17, 2005 7:34:00 AM
10 days from order to delivery. Direct from the website.
Steve*R
Thursday, February 17, 2005 9:37:00 AM
I split an order of the cheapest water absorbing polymer crystals you can buy on-line, under a 100 lb. bulk purchase. $15.00 for two pounds shipped.

I bought the 2mm crystals and used a 50/50 mix. Within a couple of weeks I knew what it would take to keep a 150 qt. cooler at 68 RH. For other coolers, 48s, 120s, I just did the math. But my conditions are different than yours. It's really best to experiment.