porter2174
Wednesday, July 13, 2005 4:06:00 AM
I recently bought a presidente humidor which holds 100 cigars, about a month ago. The humidor has a pull out piece of cedar that holds the two humidifiers. I pulled out the humidifiers yesterday and noticed mold building up in the wood. Should I clean it out, is it a problem and what can I do to avoid this from happening? Thanks guys
porter2174
Wednesday, July 13, 2005 4:07:00 AM
i'm so new i can't spell newbie....
cadbeans
Wednesday, July 13, 2005 4:40:00 AM
what you should do is buy some of the humidification beads....do a search for climaxx beads or conserva gel. Also check out these two sites.....

http://www.cigarbid.com/auction/forum/forum.cfm?action=list&forumID=1&messageDisplay=0000000034179 

http://www.cigarbid.com/auction/forum/forum.cfm?action=list&forumID=1&messageDisplay=0000000034730 

cadbeans

MA2 USN

Sasebo Japan

mrkmitch
Wednesday, July 13, 2005 4:54:00 AM
To answer your question,...

The wood should be discarded, or at a minimum should be cleaned with bleach to kill the mold spores, but this may damage the wood beyond repair. It will difinitely discolor the wood. If not, the mold will return if you just wash it off with soapy water. The mold spores will be deposited in the wood when the mold blooms, which is what you're seeing (mold bloom). This has happened because the foam humidifier has been over charged with water (hopefully distilled) and the moisture has run out and collected in the wood holder. If you haven't been using distilled water then that is the source of the original mold spores. If using foam credp type humidifiers always use distilled water to charge them, or a prepared 50/50 solution of distilled water and propylene glycol.

xrundog
Wednesday, July 13, 2005 5:32:00 AM
You can use denatured alcohol to clean up the mold. No residue or odor that way. I dunno about using bleach. Lightly sand whatever remains with 150 grit.

Many foam humidifiers have slots on the back as well as the front. Sitting right on the wood, it causes the wood to mold. Switching to a type without the back slots would solve the problem. You can buy humi-bead humidifiers. They are more costly than oasis type but last almost forever and are much more reliable and easy to use. You could also buy some beads and put them in your existing humidifier bodies for a less costly fix.

porter2174
Wednesday, July 13, 2005 5:59:00 AM
can it spread, I just bid on some of that humicare jar stuff so I will switch to that, is that stuff any good, I will pull the wood out and lay the humidifiers on paper towels until I make the switch I guess.....Thanks
cadbeans
Wednesday, July 13, 2005 9:02:00 AM
The Humicare works ok. What I did until my beads came it was I just took a shot glass and filled it with distilled water and that worked perfect.

cadbeans

MA2 USN

Sasebo Japan

Thom
Wednesday, July 13, 2005 9:45:00 AM
beads beads beads

You won't regret the purchase.