smokedog7
Sunday, December 18, 2005 6:22:00 AM
I got a new humidor for an early x-mas present from my girl. I think this is a maybe a 150ct.

I was just wondering that since I am having problems maintianing the humidity in my other box,

am i going to have a problem with "seasoning" this one?

I have charged the humidifer with 50/50 solution and have a shotglass of distilled water sitting in it now.

I am using 65% beads and a regular humidifer in my other box and i can't get the humidiy past 59-60%.

JJMD
Sunday, December 18, 2005 6:25:00 AM
If it's a new humi, give it time to equilibrate. This may take a few days. Make sure the seal is tight and make sure your hygrometer is calibrated (if analog) or the batteries are good (if digital). A salt test may be in order just to make sure your readings are accurate.
burgess_b
Sunday, December 18, 2005 6:26:00 AM
i would go with straight distilled water, rathre than 50/50...but that is just me.

you did not put 50/50 with the beads, did you???

andytv
Sunday, December 18, 2005 6:45:00 AM
in my experience, beads have been dead nuts ON.......I trust them even if my cheap hygrometer says otherwise.
mellowfellow
Sunday, December 18, 2005 6:55:00 AM
I would get a digital hygrometer just to make sure. I had the same problem until I switched to Digitals and finally saw the light.
dadank73
Monday, December 19, 2005 3:54:00 AM
Make sure you have an air tight seal, make sure you have the proper amount of beads and take the other humidification source out, check the calibration (mine reads 69% after the salt test so the humidity is right at 65% with a 59% reading while in the cabinet)

Beads work perfect if you follow all the above.

Goodluck

ST

TBWCW
Monday, December 19, 2005 5:23:00 AM
Are you using enough beads? I've had the same problem and it was due to not having enough surface area exposed to get the necessary volume of water into the air. Another dish with beads might help. Just my 2 cents.
smokedog7
Tuesday, December 20, 2005 12:38:00 PM
No B, i just used the 50/50 to charge the new humidifer.

I let this thing sit from Sat. afternoon till about 6:30 this morning with the shotglass of distilled water and the humidty never got past 55%.

Did the salt test on my hygro, it's reading 71%, so does that mean 67% in a humidified humidor with 65%

beads?

smokedog7
Tuesday, December 20, 2005 11:24:00 PM
^
GDColson
Tuesday, December 20, 2005 11:33:00 PM
Salt test is supposed to register a 75%...so if yours reads 71, then your hygro reads four low. So, if you want 65% humidity, your hygro would read 61.

I agree with mellow, though...digitals are a lot less hassle.

Also, wkelly brings up a good point. Your beads can't release/absorb moisture in your humi if enough of them aren't hitting the air. I've got mine in a half shell of a "trave" soap dish, and that seems to do the trick for my 250 humi.

GDColson
Tuesday, December 20, 2005 11:34:00 PM
oops... "trave" = "travel"
smokedog7
Friday, December 23, 2005 1:07:00 AM
I'm pretty sure they are gettin enough air. I got them in the perferated tube setting on top of the little frame box(?) that held the humidifer that came with the box.

Thanks GD and all.

By your estimates i'm close, minus 1 or 2%