I just put a cigar oasis humidifier in my Indulgence table humi. I acquired it to humidify a cabinet humi I have in the design phase, but wanted to try it out.
For those unfamiliar, the device is a smartly controled fan circuit, which senses humidity, and turns on a fan to circulate moist air (from a green foam resevoir) until the desired RH is met.
The indulgence humi's upper deck is compromised of three tiers of smokes.......the bottom, the middle tray, and the top tray. Each holds in excess of 150 cigars and is slotted at the bottom for air flow.
I put the oasis on it's side in a section of the bottom of the humi and set it to 65%. With the trays installed, their is probably 1/2" of clearance above the device.....presumably leaving adequate room for the flow of the moist air.
It has run in this configuration for two days, and I have noticed that the top tray (where my hygrometer is placed) is only registering 60%RH..........while the Oasis (at the bottom) is reading closer to 65-66%RH.
This makes sense right? The device's humidity sensor is close to the moisture supply........it OUGHT to be a little higher. BUT............isn't this like putting a thermostat directly under an AC vent?
It is easy to deduce that the Cigar Oasis is not suitable for a compartmentalised humidor, but then what IS?????
Beads SEEMED to work fine inthis humi, but I now am concerned that I was overmoistening them (in the bottom tier) in order to get the correct results at the top of the humi.
What are your thoughts..............
Stick with beads in the bottom?
Smaller bead bag for each tray?
Oasis with some flow paths cut in the trays?
Steak and Potatos?