pacman357
Thursday, February 22, 2007 9:00:00 AM
Was smoking a 60 ring La Aroma de Cuba last night. Good cigar, glad I got a box. I like the tubos better, but these are good. Smoked this one OTT, which may be part of the problem, but I've noticed the same problem on some other large ring cigars. Had trouble keeping the wrapper lit all the way around. I had it lit evenly, and it started burning evenly. However, it kept wanting to tunnel, and I'd have to touch up the end of the wrapper to keep the whole thing going.

I tend to smoke cigars fairly quickly. I wasn't babying it nor was I ignoring it. I'd get large volumes of smoke going, then the wrapper would start to fizzle out. I've noticed this with some other big rings, such as the occasional Inmenso.

Anyone else have this problem? Other than continually touching up, any suggestions?

rcfl
Thursday, February 22, 2007 9:22:00 AM
PC did you notice the draw being on the tight or the loose end, other than being too wet the draw itself is the only problems I can think of that have caused a large ring smoke to self-extinguish. I too prefer a larger ring smoke, usually resulting in a cooler and more flavorful experience.

Richard

315press
Thursday, February 22, 2007 9:43:00 AM
The problem is that you need to inhale at a force equal to an exhale of 7 PSI. Take a tire gauge and place your lips around it and blow. Blow with enough force to get a reading of 7 PSI. Now try and replicate this same force with an inhale. This is the amount of force needed to properly draw from your cigar. Too much and you could get a "blow-out". Too little and your cigar may go "flat".
Rclay
Thursday, February 22, 2007 9:47:00 AM
Pacman357 does OTT mean "On The Toilet"? kidding. I have same trouble with large ring gauge. My comfort zone is 46-60. Anything more makes me nervous.
deadeyedick
Thursday, February 22, 2007 9:59:00 AM
Often this is the result of the wrapper selected not matching well with the filler and binder blend. (ie burning rates are different)

Also, since this was OTT the filler/binder may have been a little drier than the wrapper. This would be fixed by time to settle down in the humi if it was the cause.

Happens in reverse often due to shipping.

DED

pacman357
Thursday, February 22, 2007 10:37:00 AM
2 Draw was just fine. A couple holes from a punch provided a nice, comfortable draw.

3 I was working it pretty good. Big cigar, something like 6 x 60, and it took me about 75 minutes to take it down to finger-burning territory.

5 Interesting thought. However, some Inmensos where I experienced the same problem had been in a humi at 62-65% for a while. I'll see how the LAdC's do after some more time, however.

315press
Thursday, February 22, 2007 12:23:00 PM
^

You do know that I was just having fun and was kidding with my post on 3, right?

heynow5151
Thursday, February 22, 2007 1:40:00 PM
^ he had a real hard time with the tire gauge, being a lawyer he found that he was blowing way to hard and when inhaling he sucked even harder.....lol

Pac, a gentile puff or two to get a smoke ring off the end before a draw is what I do. I smoke 48-60 ring almost exclusivly and have not had that problem.

The extra puff seems to have the cone a little hotter and maybe try knocking the ash off so it maintains the heat for the wrapper. The larger rings smoke a little cooler anyway so it does seem to effect the taste.

Being a newbie I may be off base but this is what I do and I have always enjoyed the larger rings....Jamie

jpotts
Thursday, February 22, 2007 1:54:00 PM
pacman357:

I seriously doubt it's the humidity, but more the construction. I'm thinking if the draw was too loose, it's because they opened up the center too much, and the interior of the stick is burning faster then the exterior. Most cigars over 38 ring are supposed to have the interior burn slower and hotter then the exterior, thereby leaving a hot "stump" at the end of the cigar.

If the draw is way loose, or surprisingly loose, that's what I'd say the problem is. It also might be that because you're using a punch, all of the oxygen is going right down the center of the stick, and not enough is being pulled in from the outer layers. And if that's the case, I don't think that there's much you can do about it except maybe not use a punch (IF you're using a punch), and clip the entire end (if that's possible) so that the draw is a little more even through the stick.

Then again, I could just be full of crap.

pacman357
Thursday, February 22, 2007 3:46:00 PM
7 Does this mean I can stop trying to inflate my motorcycle's tires orally? I figured you were, but it's more fun to treat it seriously. Besides, it sounded like some of that "only found on CSI" science (no kidding, CSI Miami Monday, their "scientist" claimed that a typical punch thrown by a human travels at 20 mph, whereas a housefly appeared to have been swatted at 40 mph...I nearly fell out of my chair laughing...I'd love to cross examine an "expert" in trial who made such a claim).

9 I've given the possibility serious consideration. I'm also wondering about the construction idea.

pacman357
Thursday, February 22, 2007 3:46:00 PM

ELEVENTEEN!

Fallsrider
Friday, February 23, 2007 2:52:00 PM
A full consistant 60 seconds between draws should allow the slower burning binder and wrapper to "keep up" with the faster burning filler. A 360 degree turn during the draw (that's turning the cigar, not you) will also help maintain an even burn.

doc

sw48362
Friday, February 23, 2007 5:39:00 PM
have had similar issues with other 60 ring gauge cigars.

Sometimes size does matter. I've moved back to the 42 - 54 gauge.

elrico
Friday, February 23, 2007 5:56:00 PM
For larger ring gauge cigars you may want to consider using a blade cutter and removing more of the cap. If you're using a punch, you're drawing all the air through the center of the cigar, almost forcing it to tunnel. I like a punch for mid-range ring gauge cigars, but find it doesn't work as well with larger ring gauges, even if the draw seems loose enough. It's worth a try anyway, right?

Cheers!

Gene363
Saturday, February 24, 2007 6:43:00 AM
Bigger cut, smoke it slower, I have a hard time smoking slowly, but it does help, albeit difficult with the flavor of an La Aroma de Cuba cigar.