andytv
  • andytv
  • Herf-A-Holic Topic Starter
Thursday, August 31, 2006 7:25:00 PM
Hmmmmm.......a manual reel mower might be easier than a gas mower for trimming around a house.
pabloescabar
Thursday, August 31, 2006 9:56:00 PM
Lord Knows You Need One...LOL
daveincincy
Friday, September 1, 2006 4:51:00 AM
Back in 1986 (still in high school), I bought a Toro, self-propelled, rear bagger when me and a couple buddies had a lawn service. I still have the mower, the only mower I've owned, and it's the one I still use to cut my lawn. I probably have it tuned once every 5 years or so, and have swapped out the blade a couple times. There's a couple parts in the rear axle that operate the self-propelling that cost about $2. I've replaced them maybe 2 times. They need to be replaced again, but I've just been pushing it now for the last 2 summers with no problems....amazing how you don't realize how much the self-propell makes a difference until it breaks, but you get used to it after a couple cuts. I don't have a huge lot, maybe ~1/4 acre that actually gets cut, but it's not flat and takes about 20-30 minutes to cut....I don't stroll. I keep saying, "this is the year I'll get a new mower," but it runs and cuts great and still starts on the 2nd pull (which is what they guaranteed when it was new). If there's a reason for me to get a new mower, it's to ditch the bagger and get a mulcher. My lot is wooded so I have a place to dump the clippings, but....my lot is wooded so I also have a lot of leaves come fall, and a bagger is a PITA in that department...while my neighbors skip the raking and mulch them up into little bits, I'm raking and emptying the bag after two rows.
bsevern
Friday, September 1, 2006 12:51:00 PM
Do not, I repeat, do not buy a Sears Craftsman mower.

When I bought my house five years ago I went out and bough a new Sears Craftsman mower (I have a postage stamp sized front lawn), it seemed like a no brainer. I remember when these mowers could sit out exposed to the elements in the winter, and would last for 10+ years iwth no problems!

Seems that Sears has gone low bidder these days as I had nothing but problems with my first new Craftsman mower. It ran great for about a year, but when I brought it out the next spring (it was covered, so no elemental issues) it would start for a second, then die. Put fresh gas in it, checked the plug, oil, and cleaned the carb. Still no go. Since it had a two year warranty, I took it back. Six weeks later Sears called me to say my mower was ready to pick up and that they'd put a new carb on it. I brought it home, and it was worse then when I took it in! Back to Sears it went. After a discussion with the store manager he agreed to give me a store credit to pick up another mower. I bought another Craftsman thinking this one was a fluke, lemon, whatever.

This time it didn't even last a year. Brought it back, and again they put a new carb on it. When I was waiting to pick it up, there was another couple in the waiting room that was on their THIRD Craftsman mower, and had similar issues. My Uncle bought their top of the line self-propelled model, and it was a lemon too. My mower with the new carb again had starting issues the following spring.

I suspect the engines are fine, but they've made some cost cutting changes to the carbs, and that's the root of everyones problems. I now run stabalizer in my mower gas, as well as a gas treatment/cleaner and so far (knock on wood) it's been running fine the past two years.

YMMV,

Cal

miketv
Friday, September 1, 2006 12:54:00 PM
That is the story with all Craftsman Power Tools.
blackdog2000
Friday, September 1, 2006 1:07:00 PM
Yup. To paraphrase Tom Cruise in Rainmain: "Craftsman sucks".

Back in the 50's it was probably a reliable brand.

That stopped LONG ago. All their power tools are some combinations of: heavy/clunky/awkward/underpowered/difficult to adjust/cords too short...the list goes on. You won't see a professional using Craftsman table saw, circular saw, router, etc.

OK, so you don't need profesional quality. That's OK. You arm will get tired, you'll make sloppy cuts, you'll pay $100 for a tool that will last one good job instead of $200 for a tool that will last for the rest of your life.

Funny story. Back in the 80's I was helping my buddy work on a house he was living in. I had been badmouthing Sears. He though that not everyone wants to pay for expensive pro tools and that Sears was fine if you're not making your living with it. Plus, they have this great return policy.

So literally 2 hours later, it's getting dark, we're making one last cut on a rake trim board with his Craftsman saber saw. He's using it. The thing freezes up. Just completely jammed. Something mechanical inside just broke and made the thing inoperable. Now we can't finish the job. Go return the saw on Monday I guess. Same thing'll happen next year.

Have I mentioned that Crafsman sucks?

Your mileage may vary. Sorry for the rant.

dapperdan
Friday, September 1, 2006 7:34:00 PM
Are we talking real push mower or motorized, I've seen your lawn. My push mower might give you a heart attack. Or you would lose that extra belly weight. LOL
jackconrad
Friday, September 1, 2006 8:01:00 PM
I have the Toro Power Pace self -propelled with electic start. It senses your speed; up to 5mph and adjust to it;. 399 at Home Depot.Many Pro's also use these.I'd reccomend it.
Mr. Jones
Friday, September 1, 2006 9:26:00 PM
Jack , that's the same mower I have but mine doesn't have the electric starter ( $299 or $349, can't remember). The self pace speed is great and adjusts according to how fast you want to walk/push.

I think Andy wants a push mower because of the back and forth trimming/not good for a self-propelled.