BikerBob1961
Sunday, September 24, 2006 7:54:00 PM
Thought this was some good info that I would post here.

1. An easy way to get a perfect cut from most double-bladedguillotine cutters is to lay it flat on a table, place the cigar init straight up, and snip. This method makes it easy to not only geta straight cut, but with most cutters it nips just the right amountof the head off your cigar.

2. A great way to keep your cigar burning evenly is to rotate theslow-burning side to the bottom. I know this seems odd, but thebottom side will burn faster because the oxygen needed to feed theflame isn't being displaced by the smoke. Try it and see!

3. Your cigar a little tight? First thing to try is to gentlysqueeze and massage it; many times this will loosen the bunchenough to fix the problem. But if that doesn't work, go for thegusto and use a skewer or ice pick to just poke a hole through itslength. Word of warning though: Do this before you light it and bevery careful!

4. To prevent your cigar from going out between puffs, give it acouple of extra quick, short draws coupled with quick exhalesbefore you take a long draw of smoke to savor against you palateeach time. You will be amazed at how this simple practice helps toimprove any difficult burning cigar.

5. Ignore what everyone keeps telling you about 70% being the idealrelative humidity for cigar storage. Many cigars are too wet atthis level and draw poorly and taste sour. You will enjoy a muchbetter smoking experience keeping your stogies closer to 65% RH.

6. Don't become anal about relative humidity. Cigar smoking ismeant to be relaxing; stressing over your humidor humidity level isa waste of time! The goal is to keep it stable... your cigars will bejust fine anywhere between 60% and 72%. In my opinion, they smokebest around 65-66%, but they are not going be harmed at a fewpoints higher or lower. The goal is to find what you like and tomaintain that level.

7. A quick and easy way to check how good your humidor's seal is isto empty it, place an energized flashlight inside, close the lid,and inspect it in a dark room. If there are any leaks or gaps, thelight will shine right through.

8. Your butane lighter doesn't seem to be working as well as itused to? Purge it! What does this mean? Purging is simple: Nexttime your lighter is empty, depress the fill stem and allow the airthat is trapped within the empty gas reservoir to be expelled. Youwill know it is properly purged when you cease to hear any hissing.

9. It is best to wait five minutes or so after a cigar is litbefore you try to remove the band. The heat of the cigar willloosen any glue that may have come in contact with your cigar'swrapper and will prevent you from tearing the leaf as your removethe ring.

10. Want to relight a cigar that you left sitting for awhile? Thebest way to do this is tap off any remaining ash, then gently blowthrough the cigar to clear any stale air. Then, as you light it,continue to blow gently through the cigar with the flame at thefoot for about three seconds before you take your first draw. Doingthis simple set of actions will greatly reduce any initial sourflavor from a relit cigar.

BikerBob1961
Sunday, September 24, 2006 7:54:00 PM
Sorry wrong board will post on right one.