RICKAMAVEN
Friday, March 23, 2007 8:25:00 PM
toby and i bought our home in mid 1969. the previous owner had added what he thought was a family rom about 18' X 25' with a brick fireplace.

obviously this became our bedroom and now our football season tv room, complete with surround sound and satellite, and out side the sliding glass door, a spa in a closed in room made from redwood .

the previous owner separated this room from the hallway with a door that slides into the wall instead of a regular old fashioned hinged door. at that time, mid 50's, they must have seen a movie where the butler slid the doors closed for the master, so he could have quiet in his library.

the edge of the door has a flip pull. you push against it and pull and the door slides out. the grip on the side of the door is a finger indentation to slide the door almost all the way to close the room.

with carpets on the floor, the door can be closed almost all the way. the indentation doesn't allow enough leverage to close the door completely always leaving a gap that the dogs can get through when i think i have them closed in the room.

i bought two small brass handles and was going to machine screw them together back to back, on either side of the door.

i drilled through the first handle hole to the other side of the door, hung the other handle on the machine screw and put on a lock nut.

i let the the handle on one side hang loose so i could drill

through the three other holes and they all went through

the door.

i put my machine scews, 8/32 X 1 3/4" and put lock nuts on all but the last one. it seem i had drilled at a slightly different angle and the screw would go through the hole but not into the 4th hole in the second handle.

i removed all the lock nuts and tried enlarging the hole in the door to get the angle correct. i broke two new drill bits, lost one of the machine screws and tripped over my drill when i went to the garage to get a replacement.

the handles are mounted, slightly off plum and the door opens and closes all the way,

38 years to think up how to correct the door problem and an hour to drill 4 holes in a door.

time for supper before i start talking about the hand grip i mounted between the security door and the front door preventing both doors from closing.

havanaone
Friday, March 23, 2007 8:29:00 PM
Well if all doesn't go right it can take you a long time to drill a door........did you have a beer while drilling the holes????
RICKAMAVEN
Saturday, March 24, 2007 2:28:00 PM
addendum

the doorway that this door is in is 36". with the handles the door has to stay open 1 3/4 inches.

every time we walk through the doorway, we bump into the

1 3/4 inch of door sticking out.