I just completed installing the hardware and cutting the spanish cedar interior to fit... Sealed it and sanded.. it is awaiting the shellac to arrive to complete the finish...

Also built two Spanish Cedar Trays to fit shown in two other pictures posted...

Hog

what treatment did you use for the top lip of the cedar? it's hard to tell if it is a simple round over or something else. the box looks nice! also what thickness is the sp. cedar and did you buy it like that or plane it down to size.

The SC is 5/16" I purchased one board from a local shop.. wanted to go with 3/8" and all they had was this thickness.. (I took it in the shorts for the board as well) the router bit I used for the lip on the SC was a 1/4" roman ogee I used the bottom half for the lip, adjusted it down and used the top half for the SC inside the box.. when the lid closes it locks into place air tight seal... the corners are mitered and cut to fit snugg..

Hog

nice...

WOW!!! It ain't even done yet and looks gorgeous bro!

I gots to get me a new tablesaw. ixlr8 pointed me to a free one on Craig's list but it was gone by the time I went to veiw.

J

John,

What part of the country you live in? I can keep an eye out for one for you... I know a guy here has two Delta's like mine.. both are plain janes and he wanted $250.00 each for them.. I was going to buy one and have it set up for strickly daddo's but I ran out of room in my shop for another one... he's got all his stuff in storage and will probably go when he goes.. he's suffering from kidny and liver failure...

Hog

^

Hog