mtstanger
Wednesday, November 8, 2006 9:50:00 AM
I have read that you can't buy a decent hand-held v-cutter, and have to spend ridiculous amounts on a tabletop model to find one that won't dull quickly. Does anyone have any experience with good hand-held v-cutters? How about sharpening of antique v-cutters? I understand that this has the potential to be a sensitive, CI-competitor question.
sw48362
Wednesday, November 8, 2006 10:02:00 AM
Use a small sharp pin knife and make your own "V".

Otherwise, I've used the cheap plastic ones sold here without a problem. Also if you wish they are easy to take apart if you want to sharpen. I use an angle file.

I like using a "V" cut on lonsdale size cigars

mtstanger
Wednesday, November 8, 2006 10:21:00 AM
I have tried the cheap plastic ones and find that they don't have a sharp enough point and end up tearing the cap of the cigar. I haven't tried sharpening them though.
mtstanger
Wednesday, November 8, 2006 10:35:00 AM
Please send any suggestions to matthewstanger at hotmail dot com. Thanks.
andytv
Wednesday, November 8, 2006 11:10:00 AM
the cheap v-cutter I bought (can't remember where) has held up wonderfully.
ASC
  • ASC
  • Aficionado
Thursday, November 9, 2006 2:59:00 AM
bought a 2 pack here for like $2.

Both are still working great. Have to apply force quickly...but the v-cut is so shallow that I've had no problem with tearing off cap.

Slimboli
Thursday, November 9, 2006 3:33:00 AM
EMS
fishinguitarman
Thursday, November 9, 2006 3:51:00 AM
My little plastic cheapo has given me no probs.
THL
  • THL
  • Herf-A-Holic
Thursday, November 9, 2006 4:11:00 AM
The Gladiator V-Cutter is what you're looking for. Teakwood and surgical stainless steel. I've had mine for about 2 years and it works perfectly. Properly used, it gives you a clean cut every time. I got mine here on C-Bid for about $15. I haven't seen them here for a while though I think they may be available elsewhere.
Sardious
Thursday, November 9, 2006 4:36:00 AM
I have never had a v-cutter tear up my stick, and I use a OLD plastic one that Rocky patel gave me from like 2001. It was just the base plastic model from the local shop and he got me one cause he said I needed to try it on some cigar he was promoting. You may want to make sure you are not cutting it too slow or that they are not dry cigars. Some thinner cigars I cut but mostly use them on box press.