rugrunner
Thursday, September 21, 2006 8:59:00 PM
My lawn mower won't run. It starts and after a minute or so it dies. If I am fast and hit the primer bulb I can eep it going but it won't run on it's own.

I changed the gas (thought there might be water in it as I left it out in the rain), checked the plug, and the air filter.

Any other advise for an intrnal combustionly challenge brother?

rugrunner
Thursday, September 21, 2006 8:59:00 PM
My kid needs to get the lawn done soon...
jpotts
Thursday, September 21, 2006 9:03:00 PM
Scissors?
rugrunner
Thursday, September 21, 2006 9:06:00 PM
She really bawks at that as she feels her 20$ a week allowence doesn't cover that much work.

Snow will be here soon, gotta get her a new shovel soon.

bsevern
Thursday, September 21, 2006 9:32:00 PM
rugrunner what kind of mower ya got?

I had the same issue, I put some stabalizer in the gas, as well as some Techron fuel cleaner (small amount, rest went into the Viper 🙂

It works great now, fires up on the first pull and runs hard. Only thing I can't figure out is how come is just sits there? Do I have to do something else?

Cal

pabloescabar
Thursday, September 21, 2006 9:34:00 PM
did you clean the plug when you had it out ? if not your float maybe sticking
jpotts
Thursday, September 21, 2006 9:48:00 PM
"She really bawks at that as she feels her 20$ a week allowence doesn't cover that much work."

Did you give her the "when I was your age, I used to have to..." speech yet?

racoonbeast
Friday, September 22, 2006 2:34:00 AM
Been through this all summer myself. Added fuel filter, cuz the factory thought it did not need one. Changed air filter. Replaced spark plug. Carefully gapped plug. Took the whole thing apart ten times and cleaned every piece. Finally discovered that water was getting into the tank somehow. Always added pristine clean gas from a pristine clean gas can, to a pristine clean gas tank on the mower. Never checked it after that, until, one day out of frustration took a look at the gas in the tank a day or so after adding it. It had water in it. Discovered the same thing several times in row. Don't know how the water got in the tank. Maybe the humidity here in central Florida? Anyway, sounds like water in the gas to me. Pour the gas from your tank into a tall glass or mason jar. You may see see six inches of gas floating on an eighth of an inch of water. Hope this helps.
ARN
  • ARN
  • Herf-A-Holic
Friday, September 22, 2006 2:35:00 AM
The stabilizer is a great plan. Pull the carb bowl and clean out the laquor that will build up. The simplest of issues is the oil, Most mower engines have a small override sensor and are built so that low or thinned oil will prevent these from running so you don't kill the motor.
zoinks
Friday, September 22, 2006 3:56:00 AM
Check and make sure your throttle linkage is working first (closest to the engine). There will be enough gas in it from priming to start, but it will die after 15 seconds or so.

Gene363
Friday, September 22, 2006 4:16:00 AM
The fuel supply line has a leak or stoppage:

* Water/trash contamination

* Dirty fuel filter

* Broken/cracked fuel hoses

* Carburetor requires repair/service

Since you found water you also need to check your gas can. My guess, the primer bulb may have a hole in it or the gas tank vent in plugged.

jackconrad
Friday, September 22, 2006 4:19:00 AM
See if it has sediment in the lines . see if you have a fuel filter , then check for a clog. Drain all the gas and oil and refill.
blackdog2000
Friday, September 22, 2006 4:35:00 AM
nice and quiet without that thing running though, isn't it? Ah, just get in the hammock and rest for a minute...speaking of Toro, where's that toro I just had...cutter...lighter...ahh........
Gene363
Friday, September 22, 2006 4:43:00 AM
If plant grass in your yard, you will have to mow it.

If you water grass, you will have to mow it.

If you fertilize grass, you will have to mow it.

If you de-thatch grass, you will have to mow it.

These are the problems, we don’t have a blade of grass in our yard, I don’t mind not mowing a lawn at all.

pacman357
Friday, September 22, 2006 7:23:00 AM
You can buy fuel additives at auto supply stores to "remove" water from the gas. Might be a good idea to add a little with each fillup if it's an ongoing problem.
Gene363
Friday, September 22, 2006 7:28:00 AM

Keep the tank full and don't leave it in the rain.

teedubbya
Friday, September 22, 2006 7:32:00 AM
if its a 4 cycle I agree with an oil change and stabil.

2 cycle I'm not so sure. Never had an issue with those environmentally devestating yet beautiful machines 🙂