from Wikipedia.......
There are two basic standards for voltage and frequency in the world. One is the North American standard of 110-120 volts at 60 Hz, which uses plugs A and B, and the other is the European standard of 220-240 volts at 50 Hz, which uses plugs C through M. The differences arose for historical reasons.
In the United States, Thomas Edison, the inventor of the first practical electric light bulb, insisted on using 110 volts direct current (DC) rather than alternating current (AC) for his electric system in New York City. However, George Westinghouse, who built the first large hydro-electric plants at Niagara Falls, decided to use AC instead of DC because it could be stepped up or stepped down in voltage using transformers. The electrical genius Nicola Tesla advised him that 240 V at 60 Hz was optimum, but authorities would not let him use more than 110 V for distribution. Eventually Edison switched his 110 V DC system over to AC as well, and so 110 V at 60 Hz became the American electrical standard, despite the fact it required conductors twice as large to carry the same amount of power as 240 V.
In Europe, the German company AEG built the first generating facilities, and chose 50 Hz because it fit better into the metric system of powers of ten (1, 10, 100). Unfortunately, 50 Hz is less efficient than 60 Hz because generators are 20% less efficient and transformers must be 30% bigger to step the voltage up and down. However, AEG had a virtual monopoly in Europe so their standard spread to the rest of the continent and eventually to Britain. Originally Europe was electrified at 110-120 V like North America, but after World War II, regulators decided to increase it to 220-240 V to reduce the amount of copper used for wiring.
American regulators would have liked to double the voltage as well, but there were far more household electrical appliances than in Europe. They compromised by adopting a split phase 240 V system, supplying 120 V on two live conductors going into each household with a single neutral. Small appliances ran on 120 V, big ones on 240 V. It was more complicated but saved copper and was backward-compatible with existing appliances. The original plugs could be used with the system, as well.